EMC QLogic Installationsanleitung PDF herunterladen (Seite 54)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

Note: If you are using QLogic STORPort driver 9.1.7.16 or later on Windows

2003, and are booting externally to an EMC array, you will need to install

using driver version 9.1.4.15. Driver version 9.1.7.16 and later require a

minimum of Windows 2003 with Service Pack 2 and STORPort hotfix

Q932755. Since these required patches/QFEs do not come preinstalled on the

Windows 2003 installation CD-ROM, you must install using the older driver

version, and then upgrade to 9.1.7.16 or later after installing the correct

service pack and QFE.

To install Windows:

1. Insert a bootable Windows CD-ROM in the drive and reboot the

system. If your system has a bootable disk already configured

from a previous installation, the software will prompt you to

press any key to boot from CD-ROM.

2. If you are installing Windows to boot from an external array disk,

you will need to supply setup with the HBA driver. To do this,

immediately after the Windows installation begins, press F6

when directed or when the blue screen appears. Otherwise,

proceed to step 6.

Pressing F6 tells the Windows installer you want to load a

third-party driver before proceeding with the installation.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 149 150

Keine Kommentare

EMC QLogic Installationsanleitung Seite 54