EMC QLogic Installationsanleitung PDF herunterladen (Seite 45)

Booting from the external storage array

Installation and Configuration

• At this point, the QLogic HBA instances should be shown

with a specific firmware version, and "AUX" should not be

listed next to the firmware, as shown in Figure 25.

• At this point, the EFI drivers, firmware, and NVRAM settings

have loaded to the HBA(s).

Figure 25 QLogic HBA instances with specific firmware version

8. Type q and press Enter to exit the QLogic EFI Utility.

9. At the EFI shell prompt, type drivers and pressEnter. Note the

entries that reference "QLogic Fibre Channel Adapter" are similar

to the listing shown in Figure 26.

Figure 26 QLogic Fibre Channel drivers

10. Make note of the first two digits (referred to as the "driver

handle") on the line that references the "QLogic Fibre Channel

Driver". If multiple HBAs are installed in the server, there will be

multiple entries, as shown in Figure 26.

The order of the HBA instances listed is the order in which they

have been enumerated by the system. This does not necessarily

correspond to PCI slot numbering. In this example, the two

QLogic HBAs installed in the server are using driver handles 5F

and 60, respectively.

a. Type

drvcfg.

b. Press Enter.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 149 150

Keine Kommentare

EMC QLogic Installationsanleitung Seite 45