EMC QLogic Installationsanleitung PDF herunterladen (Seite 48)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

• By default, option 1 (Enable Hard Loop ID) is disabled.

– In FC-SW environments, the default of disabled is the

proper setting.

Select 2. Auto Topology: Pt to Pt first.

Press Enter when your choice has been selected. The

Top ol og y information toward the top of the screen will

reflect your selection.

Press <Escape> to return to the previous configuration

window.

– In FC-AL/"direct attach" environments, Hard Loop ID

should be enabled.

Type 1 and press Enter. The utility will prompt to Enable

Hard Loop Id [n]?.

Type y and press Enter. Enable Hard Loop Id will now be

shown as [y] (enabled).

Type 0 and press Enter to return to the previous menu as

shown in Figure 28 on page 45.

Figure 30 Connection option

• By default, option 6 (Connection option) setting of Loop

Preferred, Otherwise Point To Point, is acceptable for most

configurations, and will auto-detect the connection topology.

– To manually set the connection topology, type 6 and press

Enter. Otherwise, type 0 and press Enter to return to the

previous menu as shown in Figure 28 on page 45.

– In FC-SW environments, Point To Point is the appropriate

setting. In FC-AL/"direct attach" environments, Loop Only

should be selected.

Type the appropriate selection and press Enter. The

selected connection topology will now be reflected.

Type 0.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 149 150

Keine Kommentare

EMC QLogic Installationsanleitung Seite 48