EMC Qlogic QLA23xx Spezifikationen PDF herunterladen (Seite 3)

Quick Start Guide

Installation Instructions

This Quick Start Guide describes how to install and configure your new QLogic SANblade

host bus adapter (HBA) in

four simple steps:

❑ Step 1. Verify the package contents.

❑ Step 2. Install the HBA hardware.

❑ Step 3. Install the HBA driver.

❑ Step 4. Install the SANsurfer FC HBA Manager.

Keep the HBA in the antistatic bag until installation. The HBA contains parts that can be damaged by

electrostatic discharge (ESD). Before handling the HBA, use standard methods to discharge static

electricity. Place the HBA on the bag when examining it. Retain the bag for future use.

Step 1. Verify the Package Contents

The QLogic HBA is shipped with the following items:

❑ QLogic SANblade HBA

❑ Low-profile bracket (not available in all models)

❑ Quick Start Guide (this document)

❑ SANsurfer CD

Step 2. Install the HBA Hardware

To install the HBA hardware, you need to open the computer and locate the appropriate bus slot. If necessary, consult

your computer system manual for instructions to remove the computer cover.

Follow these steps to install the HBA hardware:

1. Power off the computer, then disconnect the power cable.

2. Remove the computer cover and find an appropriate empty bus slot.

3. Pull out the slot cover (if any) by removing the screw or releasing the lever.

4. Grasp the HBA by the top edge and seat it firmly into the appropriate slot.

5. Refasten the HBA’s retaining bracket using the existing screw or lever.

6. Close the computer cover.

7. Plug the FC cable into the HBA.

8. Plug in the power cable and turn on the computer.

CAUTION!

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

EMC Qlogic QLA23xx Spezifikationen Seite 3