EMC Qlogic QLA22xx Installationsanleitung PDF herunterladen (Seite 45)

Configuring a Symmetrix Boot Device

3-9

Configuring an EMC Boot Device

2. To load the HBA risc code onto the HBA, type rw and press

ENTER. The firmware image binary filename, by default, is

ql2312fw.bin. The EFIUTIL program will prompt for the

filename, but pressing

ENTER will select the default. Confirm that

the version being installed is correct by typing

Y and pressing

ENTER. The firmware will begin flashing to the HBA. The

efituil> prompt will reappear when the load is complete.

3. To load the EMC NVRAM settings to the HBA, type nw and press

ENTER. The

NVRAM data filename provided on the HBA kit is

NVRAM23.DAT. The EFITUIL program will prompt for the

filename. Type

NVRAM23.DAT at the prompt and press ENTER. The

EFITUIL program will load the NVRAM settings to the HBA and the

efituil> prompt will reappear.

4. Type

quit to exit the EFIUTIL program and return to the EFI

shell.

5. Type

reset at the EFI prompt to reboot the server.

Configuring QLogic EFI boot code to boot from an External Array

QLogic EFI boot code configuration is text-based. It involves running

a command line utility to setup the HBA for boot. The following

procedure should be conducted after you have done the following:

1. Write down the world wide name for the port that you will be

booting from on the storage array. Consult your documentation

or EMC customer service rep. to determine this number for your

array.

2. Determine and note the LUN on the array that you will be

booting from.

To configure the EFI boot code, you must start the EFI driver utility

for the HBA. To do this, you must determine the driver handle and

driver control number for the HBA you will be booting from:

1. Enter the EFI shell on the system

2. At the

shell> prompt, type drivers and press ENTER. The list of

currently loaded drivers will be displayed. The QLogic EFI driver

should appear on a line that is similar to that shown below:

5D 0000011E B X X 1 HP 2 Gb Fibre Channel Driver PciRom Seg=00000000

5D 00000140 D X X 1 - Qlogic Fibre Channel Driver PciRom Seg=00000000

QLogic_Windows.book Page 9 Friday, May 27, 2005 3:53 PM

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 105 106

Kommentare zu diesen Handbüchern

Keine Kommentare

EMC Qlogic QLA22xx Installationsanleitung Seite 45

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung EMC Qlogic QLA22xx